Operations Manual
7. CONTROL UNIT OPERATION — TYPE 1 AND
TYPE 2
Envirotainer RKN e1 Container
Fig. 19
4.
• Check that no alerts or alarms are
activated.
The yellow or red LED indicator is
flashing and the alert or alarm is
displayed (Fig. 19 ) if any alert or
alarm is activated.
• Note the alert or alarm and refer to
chapter 8. Operation Modes, Infos,
Alerts And Alarms for recommended
actions.
It is also possible to view activated alerts or
alarms in the control unit menu.
• Press to enter the main menu; the display shows "TEMP MENU".
• Use or to step to "SYSTEM MENU" and press to confirm; the display shows
"ALARM VIEW".
• Use or to step to "ALERT VIEW" and press to confirm; the display shows
activated alerts. The activated alert is shown as ALERT 1/1.
7.2.6 CALIBRATION STICKER
In order to ensure that the control unit is calibrated within a 12 month period there is a
calibration sticker placed on the control unit. Calibration must be performed prior to the
month indicated on the sticker (Fig. 20 ).
Example: if a container was calibrated in October 2016 it must be re-calibrated before the start
of October 2017.
Please contact the Envirotainer Customer Care team for advice, if calibration is not performed:
customercare@envirotainer.com
7.2.7 SEAL CONTROL UNIT AND INFO BUTTON
• Use the rectangular opening in the latch to seal the control unit (Fig. 20 ).
• Use a seal with a cross section of at least 2 mm (0.08").
(PROCEED ON NEXT PAGE!)
Doc No. MO-RKN-3009
Version 2.2: 2017-08-31 26 (42)
To Next Page
Loading...