P a g e | 108
4. The “Remove ID from Site in Configuration file” message will appear. If the user is
sure that they wish to delete that ID, then they can tap the “OK” button. If the user
does not want to delete this ID, then tap “Cancel”.
5. The user may now return to the Analyze or Utilities menu by tapping the “Analyze” or
“Utilities” button at the bottom of the touch screen.
6.9.1.6 Mark Location
If the user is at the monitoring point, the GPS location or Well Barcode may now be recorded by using
the mark feature. This feature is located in the “Well ID Maintenance” section of the program and may
be accessed from the Utilities screen or the “Select ID” screen.
1) Using the dropdown menu for site and ID, select the ID that is to be marked.
To Next Page
Loading...