P a g e | 81
Once the user makes an adjustment and the sensors have stabilized the user can tap the “Lock
Adjusted” button. The button will then change to “Unlock Adjusted”. If the “Unlock Adjusted” button is
pushed it will unlock the adjusted values allowing them to fluctuate. The user may now lock the value
again. Failure to lock the values will result in the adjusted values not being stored in the output file.
The user may also access the pressure sensor calibrate (zero pressures) screen from these screens.
Make sure that the hoses are disconnected and sheltered from the wind when calibrating the pressure
sensors. For calibration instructions refer to section 6.5.3.
To Next Page
Loading...