EOS ProControl 2 plus Series - I;O Summary

ProControl User’s Manual v2.2X
17 \8100\0074_1017
IO SUMMARY
Use the Enter key to enter the I/O summary. The analog input values 0-10
represent a percentage of full scale (i.e. 2 @ 4 mA, 5 @ 12 mA). Set HiLo is used
to toggle between input/output summaries. An underscore represents an open
input or an unswitched output. A block indicates a closed input or a switched
output. An x or X is displayed when an output is not enabled and is unswitched or
switched, respectively. An asterisk (*) will be displayed if an output is declared as
a lamp and a lamp test is currently being performed. The Field key can be used to
move the blinking cursor through the outputs. The Up/Down keys can be used to
toggle the state of the
output whose position is covered by the blinking cursor.
The Enter key will return the ProControl back to its standard menus. If you press
any other keys you will see an informative message telling you which keys are
valid. The message will be displayed for 3 seconds if no keys are pressed, but can
be interrupted before the 3-second period by pressing the Enter key.
Menu
TAGNAM DIM
IO SUMMARY
>MANUAL
DIN
0123456789
10
01234 AIN
xxx DO
xxxxxxxxxxxxxxxx EXT
xxx DO
xxxxxxxxxxxxxxxx EXT
xxx DO
xxxxxxxxxxxxxxxx EXT
HILO, FIELD, UP/DOWN
CHANGE IO,ENTER EXIT
xxx DO
xxxxxxxxxxxxxxxx EXT
TAGNAM DIM
IO SUMMARY
>MANUAL
Enter
Hi Lo
Set
Field
Ÿ
Up
⁄
Down
Mode
Auto
Enter
Enter