ep EPT20-ET2 - Running, Swerving and Braking

REV. 09/2022
B6
REV. 09/2022
B7
2.Steering
Rotate the operation hand shank leftward or
rightward as required.
Rightward
Leftward
3.Braking
Mechanical operating brake
The truck is braked when the operating
handle is released.
The mechanical brake engages when the
tiller is positioned in Braking area.
Braking
area
Braking
area
If the control handle moves slowly into
the brake position, identify the cause and
rectify the fault. If necessary, replace the
gas spring!
CAUTION
1.Running
Running area
Running area
Drive switch
Control the running direction and speed of the
truck using the drive switch (1). (the large the
rotary angle, the faster corresponding speed)
1.2.4 Running, swerving and braking
1
Forward
Backward
When using the truck on a ramp or a
uneven road, please lift the leg of the forklift
to prevent its bottom from colliding with the
road surface.
i
NOTE
Creep speed
1
Keep the control handle in the vertical state,
and press creep speed button (1) and drive
switch (2) at the same time, then the vehicle
will move at a low speed.
2