ep EPT20-ET2 - Operating the Truck Without Its Own Drive System; C Battery Use and Maintenance; Safety and Warning; Safety Regulations for Handling Batteries

REV. 09/2022
C1
REV. 09/2022
B14
Battery use and maintenance
C
1.1 Safety and warning for EPT20-ET2
Safety regulations for handling batteries
The truck must be parked and rendered safe before any operations on batteries are under
taken.
-These trucks are equipped with maintenance-free batteries. No distilled water can beadded
to this battery type.The cell covers are xed tight and must not be opened. Opening the
covers will damage the battery.
-Smoking and naked ames are not permitted when handling batteries. No inammable
substances or spark-generating materials must be present or stored within a distance of 2
meters of the truck parked for battery recharging. The location must be well ventilated and re
ghting equipment must be kept ready.
-Only trained and authorized personnel are permitted to charge, service and replace the
batteries.
-Batteries are recycled in accordance with national regulations; please comply with the
relevant regulations.
1.1.1
Servicing of lead-acid batteries
The lead-acid battery cell screw caps must be kept dry and clean. Terminals and cable shoes
must be clean, lightly greased with pole grease and must be securely tightened.
Daily Maintenance
Charge the discharged battery;
Visual inspection for excessive dirtiness and mechanical damage after the charging.
• Abide by the operation
manual!
• All the operations related
to the storage battery must
be implemented under the
instruction of professionals!
• Always wear protective
clothing (e.g. safety goggles
and safety gloves) when
working on cells and
batteries.
• Explosion or re disaster is
likely to occur; avoid short
circuit!
• Don’t knock over the storage
battery!
• Using lifting and delivery
devices as specied. Prevent
the storage battery cell,
interface and connection
cable from being damaged by
the lifting hook!
1.1.2 Safety and Warning for equiped
1.3 Operating the truck without its own drive system
If the truck has to be moved after a failure has
rendered it immobile, proceed as follows:
Set the emergency stop switch “OFF”.
Set the key switch “OFF” and remove the key.
Prevent the truck from rolling away.
Remove the cover.
Screw in two screws(1), M4*30mm)until the
truck can be moved (no braking action).
Set the emergency stop switch “ON”.
Set the key switch “ON”, which the truck
powered all the time.
After setting down the truck at the destination,
unscrew two screws(1).
Braking action is restored.
•
•
•
•
•
•
•
This operating mode is not permitted
when negotiating inclines and
gradients.
WARNING
Inoperative trucks movement after brake
release must ensure that the power of
the truck is on or risk damaging the truck
controller.
i
NOTE