REV. 09/2022
B8
REV. 09/2022
B9
1.Lifting
1.2.5 Goods picking
Keep pressing the lifting button until
reaching the required lifting height
2.Lowering
Lower the pallet forks to the bottom through
pressing the lowering button.
Fig1115-00024OM
Goods failing to be arranged and fixed
may result in accidents.
To avoid shortening the service life of the
oil cylinder, try not to lift the pallet forks to
the highest state for every lifting operation.
WARNING
NOTE
Fig1115-00025OM
Emergency reverse switch
To protect the driver from any risk of being
trapped between an obstacle and the
machine,the end of the tiller is tted with a
emergency emergency reverse switch.
Once the safety reverser is triggered, the
equipment will stop immediately, then slowly
move back in the direction of the fork.
Reverse braking
Braking can be accomplished by changing
the direction of travel.
Press the drive switch in the opposite
direction until the truck comes to a stop,
then release the drive switch.
Open the drive switch; if the drive switch
cannot quickly return to the initial position
or resets very slowly, identify the cause
and rectify the fault.
CAUTION
Regenerative braking
Release the drive switch. The drive
switch will automatically return to the
initial position and the vehicle will begin
to enter the regenerative braking state.
When it decelerates to <1 km/h, the
electromagnetic brake will bring the motor
to a stop.
Emergency stop switch
Press the emergency stop switch, and then
all the electrically propelled functions will be
interrupted.
To Next Page
Loading...
