Epilog Laser Fusion Pro 48 User Manual

- 15 -
SECTION 2: GETTING STARTED
4. Slide the front panel out of the box.
5. Remove the outer screws holding up the two
braces.
6. Remove the braces as well as the plastic
bag, and any foam pieces around the
machine.
7. Using the top panel you removed at the
beginning, align its corners with the ledge on
the bottom of the box, making a ramp.
Secure the ramp with a screw.
8. Roll the machine down the ramp slowly and
carefully until it is out of the box and on level
ground.

Epilog Laser Fusion Pro 48 Specifications

General

Brand	Epilog Laser
Model	Fusion Pro 48
Category	Engraver
Language	English