ADAPT 360 | ADAPT 360 White Bluetooth
®
headset
Listening to audio using the headset18
Listening to audio using the headset
You can listen to audio via a connected device.
Controlling media playback
The following functions depend on the connected device.
X Play the media on your connected Bluetooth device.
The LED on the dongle lights up blue.
x
Plays audio
Pauses audio
Plays the next track in the playlist
Plays the previous track in the playlist
Fast-forwards the track: Press and hold the button
Rewinds the track: Press and hold the button
i
If you receive and accept a call, audio playback is paused and restarts after the call – if supported by the
connected device.
Using the audio cable
Use the audio cable for audio playback when the battery is low or when Bluetooth transmission is restricted or not
allowed. Bluetooth immediately turns o once the audio cable is connected to the headset.
X Insert the small jack plug into the audio socket of the
headset.
X Turn the plug clockwise until it locks into place.
Bluetooth is deactivated.
X Connect the 3.5 mm jack plug to the audio output of
your mobile device.
To disconnect the audio cable:
X Turn the plug counterclockwise to unlock it and pull it
out of the headset.
X Pull the plug out of your mobile device.
The headset automatically tries to connect to available
paired Bluetooth devices.
i
You can use the Active Noise Cancellation (ANC) as usual (see page 12).
ADAPT 360 | ADAPT 360 White Bluetooth
®
headset
Additional functions19
Additional functions
Charging the headset battery
X Connect the supplied USB cable to the USB socket of the headset and a USB socket of your computer.
USB-A
The battery is being charged. The LED lights up depending
on the battery status of the headset and turns off when
the battery is fully charged.
LED Battery status
100% – Battery fully charged
more than 60%
more than 20%
less than 20%
To end charging:
X Disconnect the USB cable from the headset.
i
When the battery is flat, the headset turns off automatically.
Verifying remaining battery power
Some mobile devices indicate the battery status of the
headset.
?
You can retrieve information on the remaining battery
power at any time – except while you are in a call:
X Press both Volume buttons.
The LED ashes shortly and a voice prompt is
announced.
When the battery power drops below 20%,
the LED flashes red and “Recharge headset”
is announced several times.
LED Remaining battery power
more than 60%
more than 20%
less than 20% – automatic voice prompt
To Next Page
Loading...
Need help?
General
