Character Tables
These character tables are selected by setting DIP switches 1-1,
1-2, 1-3, and 1-4, or by using the ESC t and ESC ( t software
commands.
For the graphics character tables, the ESC 6 and ESC 7 software
commands let you select whether hex codes 80 to 9F are
characters (ESC 6) or control codes (ESC 7).
All the graphics character tables are the same for hex codes 00
through 7F. Therefore, only the first table is shown completely.
Italic Character Table
A-2 Appendix
To Next Page
Loading...
