Epson 5000+ - Connecting the Printer to Your Computer

5. To stop the self test, press the PAUSE button (you can resume
the self test by pressing the
PAUSE button again).
6. Press the
LOAD/EJECT button to eject the paper from the
printer and then turn the printer off.
If test results are not satisfactory, see Chapter 6.
Here is part of a typical self test in LQ mode.
Connecting the Printer to Your Computer
If the self test prints correctly, you are ready to connect your
printer to the computer. Use a shielded twisted-pair parallel
cable to connect your computer to the printer’s built-in parallel
interface.
Setting Up the Printer
1-13