To use your printer and its software with a PC, your system should have:
◗ An IBM
®
compatible PC with at least a 486/25 MHz (for Windows 95 or
Windows NT
®
4.0), or 486/66 MHz (for Windows 98) processor
◗ Microsoft
Windows 95, Windows 98, or Windows NT 4.0
◗ At least 16MB of RAM (32MB for Windows 95 or 98 or 64MB for
Windows NT 4.0 recommended)
◗ At least 50MB of free hard disk space (100MB recommended)
◗ VGA, Super VGA, or better display adapter and monitor
◗ Double-speed (2x) CD-ROM drive—quad-speed (4x) or faster
recommended—for installing the printer software
◗ For parallel connection, a high-speed, bidirectional, IEEE-1284
compliant parallel cable (6 to 10 feet long). The cable must have a
D-SUB, 25-pin, male connector for your computer and a 36-pin,
Centronics
®
compatible connector for the printer.
For USB connection to a computer with Windows 98 and a
Windows 98 compliant USB port, a shielded USB “AB” interface cable,
from Series A (computer) to Series B (printer) up to 6.5 ft. (2 meters)
long.
Using an improperly
shielded USB cable—
especially a cable
more than 6.5 ft.
(2 meters) long—may
cause the printer to
malfunction.
To Next Page
Loading...
Need help?
General