Epson AM-C6000 Series - Page 88

c
Important:
e
following environment is necessary for linked printers.
O Epson Print Admin Serverless is available.
O Pull Printing is supported.
O Epson Print Admin Serverless settings are set to the same values.
O When using an additional network interface board, it only receives print jobs on an additional network
interface.
You can print the received print jobs from the printer registered as the slave printer.
When printing by linking to a dierent model of printer, printing may not be possible depending on the print
settings.
Related Information
& “Printing is not possible because the print job cannot be selected on the printer linked with pull printing.” on
page 114
Linking the Printer
(Conguration
Template)
1. Select Epson Open Platform Settings > Epson Print Admin Serverless > Pull Printing from the
conguration
template.
2. Set the linked printer from 1: to 5:.
You can use the IPv4, IPv6, or FQDN format for
conguration.
You can use the following format for FQDN
(<host name>. <domain name> format).
O Host name: You can enter 2 to 63 bytes in US-ASCII numbers, letters, and hyphens (except leading and
trailing).
O Domain name: You can enter 2 to 249 bytes in US-ASCII numbers, letters, and hyphens (except at the start
and end of the string). Periods can be used as a delimiter, but you cannot enter more than one period
consecutively. Also, use periods to separate the strings so that each string is 63 bytes or less.
Setup & Administration Guide
Information Registration and System Conguration
88