Epson AM-C6000 Series - Synchronizing with the LDAP Server (Configuration Template)

Item Settings and Explanation
ID Number Attribute Specify the attribute name to be used when searching for an ID number. Enter a
combination of between 0 and 255 characters using A-Z, a-z, 0-9, hyphens (-), and
semicolons (;). The rst character should be a-z or A-Z.
Example: employeeId
Department Attribute Specify the attribute name to be used when searching for a department name.
Enter a combination of between 0 and 255 characters using A-Z, a-z, 0-9, hyphens
(-), and semicolons (;). The
rst
character should be a-z or A-Z.
Example: department
Email Address Attribute Specify the attribute name to be used when searching for an email address. Enter
a combination of between 0 and 255 characters using A-Z, a-z, 0-9, hyphens (-),
and semicolons (;). The rst character should be a-z or A-Z.
Example: mail
Synchronizing with the LDAP Server (Conguration Template)
Set the LDAP server settings used for the authentication method and the search attributes used to identify the user
information.
Set this when you select Remote DB or Local DB and Remote DB as the Authentication Method and LDAP is
selected as the Remote DB.
It can be used as a redundant system of the LDAP server.
Note:
e LDAP server settings that are set here are shared with the settings for Network > LDAP server > Server Settings
(Primary Server) and Server Settings (Secondary Server) used by Contacts. When you change one value, it is reected in
the other.
1. Select Epson Open Platform Settings > Epson Print Admin Serverless > LDAP server from the
conguration template.
Setup & Administration Guide
Information Registration and System Conguration
73