Epson AM-C6000 Series - Page 74

2. Set each item.
See the related information for the items.
Related Information
& “LDAP Server Setting Items” on page 74
& “Kerberos Setting Items” on page 75
& “Search Setting Items for LDAP Server Authentication” on page 76
LDAP Server Setting Items
Click Settings for Server Settings (Primary Server).
When you select Kerberos Authentication for Authentication Method, make Kerberos settings from Network >
Security > Kerberos Settings.
Item Settings and Explanation
Use LDAP Server Select when you use LDAP server.
LDAP Server Address Enter the address of the LDAP server. Enter between 1 and 1024 characters of
either IPv4, IPv6, or FQDN format. For the FQDN format, you can use alphanumeric
characters in ASCII (0x20-0x7E) and "-" except for the beginning and end of the
address.
Port Number Enter the LDAP server port number between 1 and 65535.
Secure Connection Specify the authentication method when the printer accesses the LDAP server.
Certicate Validation When this is enabled, the certicate of the LDAP sever is validated. We
recommend this is set to Enabled.
To set up, the CA Certicate needs to be imported to the printer.
Search Timeout Set the length of time for searching before timeout occurs between 0 and 99999.
Setup & Administration Guide
Information Registration and System Conguration
74