Epson Artisan 810 - Page 273

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
Artisan 835/725/PX820FWD/TX820FWD/PX720WD/TX720WD Disassembly/assembly 273
Confidential
Install the Ink System as follows:
1. When the Carriage Lock sticks out, rotate the Combination
Gear in the direction of the arrow to lower the Carriage Lock.
Figure 8-24. Installing the Ink System (1)
2. Press the switch lever in the direction of the arrow and move the
Transmission Arm upward by rotating the Spur Gear to make a
room.
Figure 8-25. Installing the Ink System (2)
Carriage Lock
Ink System
Combination Gear
Porous Pad
Transmission Arm
Transmission Arm
Spur Gear
Switch lever
Transmission Arm
3. Align the dowels (x2) and the positioning hole (x1) of the Ink
System with the positioning holes (x2) on the Main Frame and the
dowel (x1) on the Transmission Holder Assy shown in
Fig. 8-26 .
Figure 8-26. Installing the Ink System (3)
4. Align the dowel of the Ink System with the positioning hole on the
Main Frame. (See
Fig. 8-22 .)
(Continued to the next page.)
Dowel
Positioning hole
Rubber seal,
head cleaner
Ink System
Dowel
Positioning hole
Transmission Holder Assy
Position A