Installing the Printer Software 7
English
Installing the Printer Software
The Epson
®
printer software on the CD-ROM supports Windows
®
95, 98, Me,
2000, XP, and NT
®
4.0.
1. Make sure the printer is connected to your computer, but turned off.
2. Turn on your computer and wait for Windows to load.
3. Insert the printer software CD-ROM. You see this screen:
If it does not appear, double-click
Setup.exe on the CD-ROM.
4. Select
Install Printer Software and click . You see the software license
agreement.
5. Read the license agreement and click
Accept. You see this window:
6. Turn on your printer.
c
Caution:
Before turning on the printer, be sure you have removed all protective
materials or you may seriously damage the printer. (See the unpacking
instructions provided with the printer.)
After a moment, the software begins installing. Follow any on-screen
instructions until you return to the Installation screen.
Note:
❏ If the New Hardware Found screen or any other wizard appears when you
turn on your printer, click
Cancel.
❏ If you’re asked to insert a Windows CD-ROM, insert it and click OK.
Close the Windows installer screen to continue installing the driver.
7. When the installation is complete, follow the instructions below to install
the Reference Guide and the Remote Configuration Manager utility.
Installing and Viewing the Online Reference Guide
Select Install Reference Guide on the Installation screen and click .
The
DFX-9000 Reference Guide icon appears on your desktop.
To view the Reference Guide, double-click the
DFX-9000 Reference Guide icon
or click
Start > Programs (or All Programs) > EPSON > DFX-9000 Reference
Guide > Reference Guide
.
To Next Page
Loading...
Need help?
General
