❏ The sprocket hole must be a circle or notched circle.
❏ The holes must be cleanly cut.
❏ If the horizontal and vertical perforations are crossed, the shaded area below should not be printed
on. Uncrossed perforations do not have this restricted area.
A:
B:
28 mm (1.1 inches)
3 mm (0.12 inch)
1. vertical perforation
2. horizontal perforation
1. crossed perforation
2. uncrossed perforation
❏ The ratio of the cut/uncut length at the perforation should be between 3:1 and 5:1. And expansion
at the perforation (when the paper is kept flat) should be less than 1 mm (0.04 inch) as follows.
1. 3 mm cut
2. 1 mm uncut
3. 1 mm or more
DLQ-3500II/DLQ-3500IIN User’s Guide
Product Information 128
To Next Page
Loading...
