59
Chapter 4 Handling
4
Handling
This chapter describes basic handling of the product.
Precautions for Handling
When handling DM-D500, be careful of the following points:
• Do not install DM-D500 in locations with high temperature and humidity, or with extreme temperature dif-
ferences.
• Avoid installing in dirty or dusty locations.
• Avoid installing on unstable locations, or in locations subject to frequent vibrations
• The DM-D500 includes a vacuum fluorescent display. When handling, be careful not to drop or hit it.
Turning and Tilting the Display
The display orientation and angle can be changed by moving the display while holding the support. The display
moves easily; so, do not force it any further when it stops. The range of movement for the display is as indicated
below.
The horizontal rotation angle of the display is limited by the stopper. Forcing it to turn beyond the limit
set by the stopper may damage the display.
With DP-501
: Maximum angle 90°
With DP-502 and DP-105
: Maximum angle 330°
Horizontal rotation
Tilt
Maximum angle 48°
(4 steps, 5 positions)
To Next Page
Loading...
