Epson DS-730 - Receiving Email Notifications When Events Occur

❏ Usage Status
Check the rst day of scanning, scanning count, etc.
Receiving Email Notications When Events Occur
About Email Notications
is is the notication function that, when events such as scanning stop and scanner error occur, send the email to
the
specied
address.
You can register up to ve destinations and set the notication settings for each destination.
To use this function, you need to set up the mail server before setting up notications.
Related Information
& “Conguring a Mail Server” on page 62
Conguring Email Notication
Congure email notication by using Web Cong.
1.
Access Web
Cong
and select the Device Management tab > Email
Notication
.
2.
Set the subject of email notication.
Select the contents displayed on the subject from the two pull-down menus.
❏ e selected contents are displayed next to Subject.
❏ e same contents cannot be set on le and right.
❏ When the number of characters in Location exceeds 32 bytes, characters exceeding 32 bytes are omitted.
3.
Enter the email address for sending the
notication
email.
Use A-Z a-z 0-9 ! # $ % & ' * + - . /= ? ^ _ { | } ~ @, and enter between 1 and 255 characters.
4.
Select the language for the email notications.
5.
Select the check box on the event for which you want to receive a notication.
e
number of
Notication
Settings is linked to the destination number of Email Address Settings.
Example :
If you want to send a notication to the email address set for number 1 in Email Address Settings when the
admin password is changed, select the check box for column 1 on the line Administrator password changed.
6.
Click OK.
Conrm that an email notication will be sent by causing an event.
Example : e administrator password has been changed.
Administrator Information > Monitoring a Remote Scanner > Receiving Email Notications When Events Occur
218