3.
Right-click the scanner, and then click Install.
Click Continue when the User Account Control screen is displayed.
Click Uninstall and start again if the Uninstall screen is displayed.
Note:
e scanner name you set on the network and model name (EPSON XXXXXX (XX-XXXX)) are displayed on the
network screen. You can check a scanner’s name that was set on the network from the scanner’s control panel.
4.
Click the message displayed on the computer, which says that your device is ready to use.
5.
Check the message on the screen, and then click Close.
Basic Scanning
>
Scanning Using the Scanner’s Control Panel
>
Scanning Using WSD
95
To Next Page
Loading...
