Epson DS-80W

If your router does not have a WPS button, see your router documentation for instructions on enabling WPS
in your router's
soware.
4. Hold down the
button on the scanner until the Ready light
ashes,
and and lights
ash
alternately (approximately 3 seconds).
When the Ready light,
and lights stay on, connection is complete.
Note:
Connection has failed when the Ready light stays on,
and lights ash simultaneously. Restart the scanner and
the router, move them closer together, and then try again.
Related Information
& “Basic Scanning” on page 37
&
“Advanced Scanning” on page 53
& “Network Problems” on page 81
Making Wi-Fi Settings by PIN Code Setup (WPS)
You can automatically connect to a wireless router by using a PIN code. You can use this method to setup if the
router supports WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the router.
1. Make sure that the scanner is turned o.
2.
Set the
switch on the scanner to on.
3. Slide the
switch while holding down the button and hold them there for approximately 10 seconds until
the ready light
ashes
to turn on the scanner.
c
Important:
You must complete Wi-Fi connection setup within two minutes.
4. Use your computer to enter the PIN code (an eight-digit number) on the label stuck to the scanner.
Connection setup starts.
e
Ready light
ashes,
and the
and lights on the scanner
ash
alternately.
When the Ready light,
and lights stay on, connection is complete.
User's Guide
Network Settings
22