Control Computer Features from a Projected Screen (Computer Interactive Mode)
112
When the projector is connected to a computer with a USB cable, you can
operate the computer from the projected screen using the interactive pens or
your finger, just as you would use with a mouse. You can navigate, select, and
interact with your computer programs from the projected screen.
a
• When you use multiple displays with Windows 7 or later and use
computer interactive mode on the secondary display, make the
following settings:
• Set the Pen Tracking Mode setting to Pen Mode in the projector's
Pen/Touch menu.
s Pen/Touch > PC Interactivity > Pen Tracking Mode
• Go to Control Panel > Hardware and Sound > Table PC Settings
> Setup to launch the setup program and configure the interactive
features.
If you set up a third display, you cannot use interactive features with
that display.
You cannot write or draw across multiple screens.
• To use computer interactive mode over a network, you need to
install Epson iProjection (Windows/Mac).
gg Related Links
• "Computer Interactive Mode System Requirements" p.112
• "Using Computer Interactive Mode" p.113
• "Adjusting the Pen Operation Area" p.113
• "Installing Easy Interactive Driver on Mac" p.115
Computer Interactive Mode System Requirements
Your computer must use one of the following operating systems to use the
computer interactive mode.
Windows
• Windows 7 Service Pack 1
• Ultimate (32- and 64-bit)
• Enterprise (32- and 64-bit)
• Professional (32- and 64-bit)
• Home Premium (32- and 64-bit)
• Windows 8.1
• Windows 8.1 (32- and 64-bit)
• Windows 8.1 Pro (32- and 64-bit)
• Windows 8.1 Enterprise (32- and 64-bit)
• Windows 10
• Windows 10 Home (32- and 64-bit)
• Windows 10 Pro (32- and 64-bit)
Mac
• OS X 10.11.x
macOS
• 10.12.x
• 10.13.x
• 10.14.x
To Next Page
Loading...
