Screen Sharing
179
You can distribute the currently projected screen image to up to four
projectors that are connected to the same network. This allows you to view
the image at the same time from other projectors.
You can also draw on the received images using the interactive function.
(Some drawing features are not available. See the interactive toolbar for
available features.)
Note the following limitations when using the Screen Sharing function.
• This function is available only for supported models.
• You cannot distribute images that are protected by HDCP.
• You cannot change the projector's Network settings during Screen Sharing.
• The Screen Type setting in the Installation menu must be set to 16:9,
16:10, or 4:3.
gg Related Links
• "Preparing For Screen Sharing" p.179
• "Sharing the Screen" p.180
• "Receiving Shared Screen Images" p.181
Preparing For Screen Sharing
You need to select settings on both the distributing and receiving projectors
before using Screen Sharing.
• On the distributing projector:
• Connect the projector to the network.
• Make sure the Screen Sharing setting is set to On.
s Network > Network Settings > Network Projection > Screen Sharing
• If you want to skip authentication of keywords for other projectors so you
can quickly connect to them, set the Connection Mode setting to
Keyword Off.
s Network > Network Settings > Network Projection > Screen Sharing
> Connection Mode
• On the receiving projectors:
• Connect the projectors to the same network as the distributing projector.
• Make sure that no computer is connecting to the projector using the
Epson iProjection software.
• Make sure the Screen Type setting in the Installation menu is the same as
the distributing projector.
• Make sure the Screen Sharing setting is set to On.
s Network > Network Settings > Network Projection > Screen Sharing
gg Related Links
• "Network Menu - Network Projection Settings" p.225
To Next Page
Loading...
