Epson EB-1480Fi - Input Signal Settings - Signal I;O Menu

Input Signal Settings - Signal I/O Menu
207
Normally the projector automatically detects and optimizes the input signal
settings. If you need to customize the settings, you can use the Signal I/O
menu. The available settings depend on the currently selected input source.
Setting Options Description
Volume Various levels
available for each
source
Adjusts the volume of projector’s speaker
system.
You can also adjust the volume of
external speakers.
Setting is only displayed when the audio
is not output to AV system.
Source — Displays settings saved for each input
source.
To change settings for an input source,
make sure the source is connected and
select that source.
Setting Options Description
Signal Format Video Signal Sets the signal type from the input
sources. If interference appears or no
image appears when set to Auto, select
the appropriate signal according to the
connected equipment.
Setting is only displayed when the
current source is Video.
Video Range Sets the video range to match the setting
of input source.
Setting is only displayed when the
current source is HDMI or HDBaseT.
Mic Input Level Various levels
available
Adjusts the input level from a
microphone.
When Mic Input Level is turned up, the
volume of the other connected device is
turned down; when it is turned down,
the volume of the other connected device
is turned up.
Setting is only displayed when the audio
is not output to AV system.
Overscan Auto
Off
4%
8%
Changes the projected image ratio to
make the edges visible by a selectable
percentage or automatically.
Setting is only displayed when the input
signal is component signal.
EDID Various values
available
Describes the display capabilities of your
projector. Change this setting as
necessary according to the resolution of
the current input source.
Setting is only displayed when the
current source is HDMI or HDBaseT.
Reset to Defaults — Resets all settings for current input
source.