Epson EB-1485Fi - Adjusting the Black Level

Using Multiple Projectors
145
d
Select Brightness and adjust the value.
e
Select Red, Green, or Blue and adjust the color tone, if necessary.
f
Go back to the top level menu and select the Operation menu and
press [Enter].
g
Select Light Source Brightness Control and press [Enter].
h
Set the Light Source Mode to Custom.
i
Adjust the Brightness Level.
j
Repeat steps 1 through 5 multiple times, each time selecting to adjust
levels 7 through 2 in the same way.
k
When you are finished, press [Menu].
Adjusting the Black Level
You can adjust the brightness and color tone of the areas where the images do
not overlap to create a seamless image (EB-1485Fi only).
a
• You cannot adjust the Black Level setting when a test pattern is
displayed.
• If the Geometry Correction value is very large, you may not be able
to adjust the Black Level correctly.
• The brightness and tone may differ in areas where the images overlap
as well as in other areas even after performing the Black Level
adjustment.
• If you change the Edge Blending setting, the Black Level setting
returns to its default value.