Epson EB-1485Fi - Projector Administration Settings - Management Menu

Projector Administration Settings - Management Menu
215
Settings on the Management menu let you customize various projector
administrative features.
Setting Options Description
User Button Light Source Mode
Info
Deinterlacing
Resolution
Mic Input Level
Pattern Display
Auto Calibration
Display LAN Info.
Installation Guide
Assigns a menu option to the [User]
button on the remote control for one-
touch access.
User's Logo Start Setting
Reset
Creates a screen that the projector
displays to identify itself and enhance
security.
Setting Options Description
User Pattern — Captures a projected screen and saves it
as a pattern for display. Select Pattern
Display on the Display menu to display
the saved pattern.
Control Panel Lock Full Lock
Except for Power
Off
Controls projector button locking to
secure the projector:
• Full Lock: locks all buttons.
• Except for Power: locks all buttons
except the power button.
• Off: no buttons locked.
Color Uniformity Color Uniformity Set to On to adjust the color tone balance
for the whole screen.
Adjustment Level Sets the adjustment level.
Start Adjustments Adjusts the red, green, and blue color
tones individually for the selected area.
Reset Resets all adjustment values on the Color
Uniformity menu to their default
settings.
Color Matching
(EB-1480Fi only)
— See the Multi-Projection menu table for
details on the Color Matching settings.
Refresh Mode Timer Sets a time period during which the
projector displays the refresh image.
Messages Set to On to display a message informing
you that the projector is in refresh mode.
Start Starts the refresh mode process to clear
any projected afterimage and turn off the
projector after a specified period of time.
Press any button to cancel this process.
Light Source
Calibration
Run Now Starts light source calibration to optimize
the color balance of the currently
projected image. You may not be able to
start calibration if the projector's
environmental temperature is out of
range. (Wait 20 minutes after turning on
the projector before starting calibration
for the best results.)