Submenu Function
Display
You can make settings related to the projector's display.
Messages: When set to Off, the following items will not be
displayed.
Item names when the Source, Color Mode, or Aspect Ratio
is changed, messages when no signal is being input, and
warnings such as High Temp Warning.
Display Background
*1
: You can set the screen status for
when no image signal is available to Black, Blue, or
Logo.
Startup Screen
*1
: Set to On to display the User's Logo
when projection starts.
A/V Mute
*1
: You can set the screen displayed when the
remote control's [A/V Mute] button is pressed to Black,
Blue, or Logo.
Toolbars (EB-536Wi only): Set whether or not the drawing
toolbar tab is always displayed when using the interactive
features. The default is Hide for Set Time.
Pen Mode Icon (EB-536Wi only): Set whether or not to
always display the icon to change the pen mode when using
the interactive features. The icon is hidden when set to
Off.
Projector Control (EB-536Wi only): Set the display position
for the projector control toolbars when using the interactive
features. The default value is Bottom. The icon is hidden
when set to Off.
User's Logo
*1
You can change the user's logo that is displayed as a
background during Display Background, A/V Mute, and so
on.
s "Saving a User's Logo" p.95
Submenu Function
Projection
Select from one of the following projection methods
depending on how the projector is installed.
Front, Front/Ceiling, Rear, and Rear/Ceiling
You can change the Projection mode as follows by pressing
down the [A/V Mute] button on the remote control for
about five seconds.
Front
W
Front/Ceiling
RearWRear/Ceiling
s "Installation Methods" p.23
Operation
Direct Power On: Set to On to turn on the projector
simply by plugging it in.
When the power cord is plugged in, note that the projector
turns on automatically in cases such as a power outage
being restored.
High Altitude Mode: Set to On when using the projector
above an altitude of 1500 m or higher.
Startup Source Search: Set to Off to project images from
the same source as the last time the projector was used.
Auto Power On: (Only available when Standby Mode is set
to Communication On.) If this is set to Computer1, the
projector turns on when signals are received from the
Computer1 port, even when the projector is in standby
mode. The default value is Off.
List of Functions
121
To Next Page
Loading...
Need help?
General
Weight and Dimensions
