c
While holding down the [Esc] button on the remote control or the
control panel, connect the power cord to the projector.
The status indicator and the power indicator turn blue, and the lamp
indicator and the temperature indicator turn orange.
When all of the projector's indicators turn on, release the [Esc]
button.
The projector is recognized as a removable disk by the computer.
d
Open the removable disk, and save the batch setup file
(PJCONFDATA.bin) to the computer.
a
If you need to change the name of the batch setup file, add text
after PJCONFDATA. If you change the PJCONFDATA section
of the file name, the projector may not be able to recognize the
file correctly. You can only use single-byte characters for the file
name.
e
Perform "Remove USB Device" on the computer, and then
disconnect the USB cable.
a
When using OS X, perform "Remove EPSON_PJ".
The projector turns off and only the power indicator is lit blue.
Reflecting Saved Settings to Other Projectors
a
Disconnect the power cord from the projector, and check that all
of the projector's indicators have turned off.
b
Connect the computer's USB port to the projector's USB-B port
with a USB cable.
c
While holding down the [Menu] button on the remote control or
the control panel, connect the power cord to the projector.
The status indicator and the power indicator turn blue, and the lamp
indicator and the temperature indicator turn orange.
When all of the projector's indicators turn on, release the [Menu]
button.
Performing Batch Setup for Multiple Projectors
139
To Next Page
Loading...
Need help?
General
Weight and Dimensions
