a
If Password Protection is already activated, you must enter
the password.
If the password is entered correctly, the Password Protection
setting menu is displayed.
s "Entering the Password" p.99
When the password is set, stick the supplied password protect
sticker in a visible position on the projector as a further theft
deterrent.
b
Select the type of Password Protection you want to set, and then
press the [Enter] button.
c
Select On, and then press the [Enter] button.
Press the [Esc] button, the screen displayed in step 2 is displayed
again.
d
Set the password.
(1) Select Password, and then press the [Enter] button.
(2) When the message "Change the password?" is displayed, select Yes and
then press the [Enter] button. The default password is set to "0000".
Change this to your own desired Password. If you select No, the screen
displayed in step 2 is displayed again.
(3) While holding down the [Num] button, enter a four digit number using
the numeric buttons. The number entered is displayed as "* * * *". When
you enter the fourth digit, the confirmation screen is displayed.
Remote control
(4) Re-enter the password.
The message "Password accepted." is displayed.
If you enter the password incorrectly, a message is displayed prompting
you to re-enter the password.
Entering the Password
When the password entry screen is displayed, enter the password using the
remote control.
While holding down the [Num] button, enter the password by pressing the
numeric buttons.
When you enter the correct password, Password Protection is temporarily
released.
Security Functions
99
To Next Page
Loading...
Need help?
General
Weight and Dimensions
