Installing the Wall mount
14
Caution
When installing two or more projectors in parallel, leave a gap of at least 1,500 mm between
the projectors.
1500mm
If you cannot secure a gap of approx. 1,200 mm, install a partition to block the heat vented from
the projector's air exhaust vent.
The partitions should be larger than the exhaust vent (approx. 20 mm in all directions), and installed
approximately 400 mm from the exhaust vent and 200 mm from the intake vents.
400mm 200mm
Install and adjust the projector at a room temperature that is close to the actual intended
usage environment.
If the temperature changes, the position of the image may shift.
We recommend using stick-on screens or board screens.
To Next Page
Loading...
Need help?
General
