Installing the Wall mount
56
Adjusting the Position of the Projected Image
You can use any of the following methods to adjust the position of the projected image.
c
When multiple projectors are installed in the same room, we recommend that you set projector IDs
to prevent remote control interference.
Turn on a projector and set the ID number for the projector in Installation > Projector ID.
(When using EB-755F/EB-750F, set from Multi-Projection - Projector ID.)
When you want to operate a specific projector, hold down the [ID] button on the remote control
and press the button with the same number as the projector ID.
•
Adjusting using the Setting Plate Installation Guide ( p.59)
Manually adjust the position of the setting plate according to the guide screen displayed. This is useful when you
want to perform fine adjustments to the projection position while maintaining the image quality.
•
Adjusting using the projector menus ( p.62)
To Next Page
Loading...
