Installing the Wall mount
62
j
Adjust the focus of position A in the following figure
k
When you have finished making adjustments, press the [Esc] button on the remote control
or the control panel to exit the guidance screen
Adjusting using the projector menus
c
•
You can save adjusted values in Memory from the Geometry Correction menu.
•
Before performing the adjustment, set the Screen Type setting first. If you change the Screen Type after
making corrections, the corrections will be reset.
Arc Correction
a
Press the [Menu] button
Using the Remote Control Using the Control Panel
To Next Page
Loading...
Need help?
General
