Setting the Projector
74
Setup by Connecting the Computer and Projector with a USB Cable
c
The following operating systems support the batch setup function.
•
Windows 7 and later
•
OS X 10.11 and later
Saving settings to a computer
a
Disconnect the power cord from the projector, and check that all of the projector's
indicators have turned off
b
Connect the computer's USB port to the projector's USB-B1 port with a USB cable
c
While holding down the [Esc] button on the remote control or the control panel, connect
the power cord to the projector
The On/Standby indicator and the Status indicator turn blue, and the Laser indicator and the Temp
indicator turn orange.
When all of the projector's indicators turn on, release the [Esc] button.
The projector is recognized as a removable disk by the computer.
d
Open the removable disk, and save the batch setup file (PJCONFDATA.bin) to the computer
c
If you need to change the name of the batch setup file, add text after PJCONFDATA. If you
change the PJCONFDATA section of the file name, the projector may not be able to recognize
the file correctly. You can only use single-byte characters for the file name.
To Next Page
Loading...
Need help?
General
