EasyManuals Logo

Epson EB-755F Installation Guide

Epson EB-755F
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
Setting the Projector
76
e
Perform "Remove USB device" on your computer, and then disconnect the USB cable
c
When using a Mac, perform "Remove EPSON_PJ".
When all of the indicators start flashing, the settings are being written.
Caution
Do not disconnect the power cord from the projector while the settings are being written. If the
power cord is disconnected, the projector may not start correctly.
When writing completes normally, the projector turns off, and only the On/Standby indicator is lit blue.
When Setup Fails
Check Remedy
Are the Laser and the Temp indicators
flashing orange quickly?
The batch setup file may be corrupt, or the USB flash drive or USB
cable may not be connected correctly. Disconnect the USB flash
drive or the USB cable, unplug and then plug in the projector's
power cord, and then try again.
Are the On/Standby and the Status indi-
cators flashing blue, and the Laser and the
Temp indicators flashing orange quickly?
Writing the settings may have failed and an error may have occurred
in the projector's firmware. Stop using the projector, remove the
power plug from the electrical outlet, and contact Epson for help.

Table of Contents

Other manuals for Epson EB-755F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EB-755F and is the answer not in the manual?

Epson EB-755F Specifications

General IconGeneral
BrandEpson
ModelEB-755F
CategoryProjector
LanguageEnglish

Related product manuals