List of Functions
44
Settings Menu
Sub Menu Function
Keystone You can correct keystone distortion in images.
H/V-Keystone : Corrects horizontal and vertical keystone distortion. Select one of "V-Keystone" or "H-Keystone".
Use the [ ], [ ], [ ], and [ ] buttons on the control panel to perform similar corrections to "V-Keystone" and "H-
Keystone".
Quick Corner: Selects and corrects the four corners of the projected image. s p.17
Control Panel Lock You can use this to restrict operation of the projector's control panel. s p.36
Pointer Shape You can select the shape of the pointer. s p.27
Pointer 1: Pointer 2: Pointer 3:
Brightness Control You can set the lamp brightness to one of two settings.
Select "Low" if the images being projected are too bright such as when projecting images in a dark room or onto a small screen. When "Low" is
selected, the amount of electricity consumed and the lamp's operating life are changed as follows, and fan rotation noise during projection is
reduced. Electrical consumption: about a 14% decrease, lamp life: about 1.5 times longer
Volume You can adjust the volume. Setting details are saved for each image signal.
Remote Receiver You can limit the reception of the operation signal from the remote control.
When you want to prohibit operation by remote control, or if the remote receiver has a fluorescent light too close to it, you can make settings to
deactivate the remote receiver you do not want to use or that is experiencing interference.
To Next Page
Loading...
Need help?
General
