95
Making a WPS (Wi-Fi Protected Setup) Connection with a Wireless LAN Access Point (EB-G5350/G5150 only)
There are two methods for setting WPS.
•Push Button Method
SSID and security are set automatically when the [Enter] button is
pressed on the projector's control panel and the dedicated button
on the access point equipment. This method is recommended
when the projector and access point are close together.
•PIN Code Method
SSID and security are set automatically by inputting an 8-digit
code that was assigned to the projector from the computer to the
access point in advance. Make connection settings between the
computer and the access point in advance. For details on how to
make this connection, refer to the manual provided with the
access point. This method is recommended when the projector is
mounted on the ceiling.
Connection Setup Method
A
Press the [Menu] button on the projector, and then
select "Network" - "Network Configuration" from the
configuration menu.
The Network Configuration screen is displayed.
B
From "Wireless LAN" select "To Setup Wizard".
The following screen is displayed.
When connecting using the Push Button Method, follow the steps
given below.
Go to "Making a connection using the PIN Code Method" when
connecting using the "PIN Code Method". s p.97
Procedure
To Next Page
Loading...
Need help?
General
