Replacing Consumables
87
E
Install the new lamp.
Insert the new lamp along the guide rail in the correct direction so
that it fits in place, push down firmly at the location marked
"PUSH", and once it is fully inserted tighten the two screws.
F
Replace the lamp cover.
f Resetting the lamp operating time
The projector records how long the lamp is turned on and a message and
indicator notify you when it is time to replace the lamp. After replacing
the lamp, make sure you reset the lamp hours from the configuration
menu. s p.64
Attention
• Make sure you install the lamp securely. If the lamp cover is
removed, the lamp turns off automatically as a safety precaution.
If the lamp or the lamp cover is not installed correctly, the lamp
does not turn on.
• This product includes a lamp component that contains mercury
(Hg). Please consult your local regulations regarding disposal or
recycling. Do not dispose of it with normal waste.
q
Only reset the lamp operating time after the lamp has been
replaced. Otherwise the lamp replacement period is not
indicated correctly.
To Next Page
Loading...
Need help?
General
