Displaying a Test Pattern
A test pattern can be displayed to adjust the projection status without
connecting video equipment. This is useful when installing a projector.
q
If the [User] button on the remote control is set to Test Pattern, the
test pattern will be displayed when the [User] button is pressed. (The
default setting is Test Pattern.)
Procedure
A
Press the [Menu] button while the projector is projecting.
Select Settings - "Test Pattern", then press the [Enter] button.
Using the Remote Control Using the Control panel
B
Press the [h] button on the remote control in the [r] direction
or press the [Enter] button on the control panel to switch the
test pattern.
To display the previous image, press the [
h] button on the remote
control in the [
l] direction.
Using the Remote Control Using the Control panel
The following adjustments can be made while the test pattern is being
displayed.
• Zoom and focus adjustment
s
Quick Start Guide
• Projected image position adjustment
s p.22
• Projected image keystone correction
s p.22
• Selecting the projection quality (Selecting Color Mode)
s p.33
• Brightness adjuctment
s Image menu - Brightness p.55
• Sharpness adjustment (Standard only)
s Image menu - Sharpness
p.55
• Color temperature adjustment
s
Image menu - Abs. Color Temp.
p.55
• Color adjustment
s Image menu - Color Adjustment p.55
Adjusting the Projected Image
21
To Next Page
Loading...
