You can save the image that is currently being projected as a User's Logo.
The saved user's logo can be used as the display image when there is no
video signal input or during the A/V Mute operation.
q
Once a User's Logo has been saved, the logo cannot be returned to the
factory default.
Procedure
A
Project the image you want to use as the user's logo, and then
press the [Menu] button.
Using the Remote Control Using the Control panel
B
Select Extended - "User's Logo" from the configuration menu.
s "Using the Configuration Menu" p.54
Check the buttons you can use and the operations they perform in
the guide under the menu.
q
• If User's Logo Protect from Password Protect is set to On, a
message is displayed and the user's logo cannot be changed. You can
make changes after setting User's Logo Protect to Off.
s p.49
• If User's Logo is selected when Keystone, E-Zoom, Aspect, or
Progressive are being performed, the function currently being
performed is cancelled.
C
When "Choose this image as the User's Logo?" is displayed,
select "Yes".
q
When you press the [Enter] button on the remote control or the
control panel, the screen size may change according to the signal as it
changes to the resolution of the image signal.
Saving a User's Logo
47
To Next Page
Loading...
