Procedure
A
Set the remote control ID switch to On.
B
During projection, while holding the [ID] button, press the
[Help] button.
Remote Control
When you press the buttons, the current Projector ID is displayed on
the projection screen. It disappears in about three seconds.
Setting the Remote Control ID
Procedure
A
Set the remote control ID switch to On.
B
While holding the [ID] button, press a number button to select
a number to match the ID of the projector you want to
operate.
s "Checking the Projector ID" p.42
Once this setting has been made, the projector that can be operated by the
remote control is limited.
Limitation of the Number of the Target Projectors when Using Multiple Projectors
43
To Next Page
Loading...
