Sub Menu Function
DHCP
You can set whether or not (On/Off) to use
DHCP
g
.
If this is set to On you cannot set any more addresses.
IP Address
You can input the IP address
g
assigned to the projector.
You can input a number from 0 to 255 in each field of the address. However, the following IP addresses cannot be used. 0.0.0.0, 127.x.x.x, 224.0.0.0 to
255.255.255.255 (where x is a number from 0 to 255)
Subnet Mask
You can input the
Subnet Mask
g
for the projector. You can input a number from 0 to 255 in each field of the address. However, the following subnet
masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address
You can input the IP address for the gateway for the projector.
You can input a number from 0 to 255 in each field of the address. However, the following
Gateway addresses
g
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
MAC Address
Displays the MAC address.
SSID Display
To prevent the SSID from being displayed on the LAN Standby screen, set this to Off.
IP Address Display
To prevent the IP address from being displayed on the LAN Standby screen, set this to Off.
Network Menu (EB-G5950/G5650W)
71
To Next Page
Loading...
