The Position, Size, or Margins of the Copies are Incorrect
e
following causes can be considered.
The paper is loaded incorrectly.
Solutions
Load paper in the correct direction, and slide the edge guide against the edge of the paper.
& “Loading Paper” on page 32
The size of the paper is set incorrectly.
Solutions
Select the appropriate paper size setting.
The originals are not placed correctly.
Solutions
❏ Make sure the original is placed correctly against the alignment marks.
❏ If the edge of the scanned image is missing, move the original slightly away from the edge of the
scanner glass. You cannot scan the area within approximately 1.5 mm (0.06 in.) from the edge of the
scanner glass.
& “Placing Originals” on page 37
There is dust or dirt on the scanner glass or document mat.
Solutions
When placing the originals on the scanner glass, remove any dust or dirt that has adhered to the originals,
and clean the scanner glass and document mat. If there is dust or stains on the glass, the copy area may
extend to include the dust or stains, resulting in the wrong copying position or small images.
& “Cleaning the Scanner Glass and Document Mat” on page 120
Original Size is wrong in copy setting.
Solutions
Select the appropriate Original Size in the copy setting.
& “Advanced Menu Options for Copying” on page 94
Solving Problems
>
Printing, Copying, and Scanning Quality is Poor
>
Copy Quality is Poor
203
To Next Page
Loading...
