Troubleshooting
71
Indicator status during an error/warning
: Lit : Flashing : Status dependent : Off
Indicators Status Remedy
High Temp Warning
You can continue projecting. If the temperature rises too high
again, projection stops automatically.
•
Make sure that the air filter and exhaust vents are not blocked,
and that air flow is not being blocked by any objects or walls
around the projector.
•
If the air filter is clogged, clean or replace it. s p.83, p.85
•
Make sure that nothing is blocking the area around the inlet
and that the temperature around the inlet is not too high.
s p.98
Internal Error
The projector has malfunctioned.
Remove the power plug from the electrical outlet, and contact
your local dealer or the nearest Epson repair center.
s Epson
Projector Contact List
Fan Error
Sensor Error
Laser Warning
A laser warning has occurred.
Remove the power plug from the electrical outlet, and contact
your local dealer or the nearest Epson repair center.
s Epson
Projector Contact List
Laser Error
A laser error has occurred.
Remove the power plug from the electrical outlet, and contact
your local dealer or the nearest Epson repair center.
s Epson
Projector Contact List
High Temp Error
(Overheating)
The internal temperature is too high.
•
The projector turns off automatically and you cannot project
until it has cooled down. Wait for about five minutes. When the
fan has stopped, disconnect the power cord.
•
Make sure that the air filter and exhaust vents are not blocked,
and that air flow is not being blocked by any objects or walls
around the projector.
•
If the air filter is clogged, clean or replace it. s p.83, p.85
•
Make sure that nothing is blocking the area around the inlet
and that the temperature around the inlet is not too high.
s p.98
•
If turning the power back on does not clear the problem, stop
using the projector and remove the power plug from the elec-
trical outlet. Contact your local dealer or the nearest Epson re-
pair center.
s Epson Projector Contact List
•
When using at an altitude of 1500 m or more, set High Altitude
Mode to On.
s Extended - Operation - High Altitude
Mode p.63
To Next Page
Loading...
