Submenu Function
Position
(This item cannot be set when the source is HDMI.)
You can adjust the display position up, down, left, and right when
a part of the image is missing so that the whole image is projected.
3D Setup
Set when viewing 3D images.
3D Display: Set to On when viewing 3D content. If this is set to
Off, 2D images are projected even when a 3D Input Signal is
being input.
3D Format: Select the format for the 3D input signal. When set to
Auto, the format is chosen automatically according to the input
signal. Normally this should be set to Auto.
3D Brightness: Adjust the brightness of the projected image.
Inverse 3D Glasses: The shutter opening timing for the 3D
Glasses is inverted from left to right. Use this if you cannot view
the 3D image correctly.
3D Viewing Notice: Set to On to display warnings regarding
viewing 3D images. Displays warnings when viewing 3D images.
Progressive
(When a component video or RGB video is being input, this
setting can only be adjusted if the signal being input is an
interlaced signal (480i/576i/1080i). This cannot be set when a
digital RGB signal is being input.)
Interlace
g
(i) signal is converted to Progressive
g
(p). (IP
conversion)
Off: Ideal for images with a large amount of movement.
Video: Ideal for general video images.
Film/Auto: This is ideal for movie films, computer graphics, and
animation.
Noise Reduction
(This cannot be set when a digital RGB signal is input or when
projecting an interlaced signal while Progressive is set to Off.)
Smoothes out rough images. There are two modes. Select your
favorite setting. It is recommended that this is set to Off when
viewing image sources in which noise is very low, such as for
DVDs.
Submenu Function
HDMI Video
Range
When the projector's HDMI port is connected to a DVD player,
set the projector's video range according to the DVD player's
video range setting.
Input Signal
You can select input signal from Computer port.
If set to Auto, the input signal is set automatically according to
the connected equipment.
If colors do not appear correctly when set to Auto, select the
appropriate signal according to the connected equipment.
Video Signal
You can select the input signal from the Video port. If set to Auto,
video signals are recognized automatically. If interference
appears in the image or a problem occurs such as no image is
being projected when set to Auto, select the appropriate signal
according to the connected equipment.
Aspect
You can set the
aspect ratio
g
for projected images.
s "Changing the Aspect Ratio of the Projected Image" p.44
Overscan
(This setting can only be adjusted when a component video or
RGB video signal is being input.)
Changes the output image ratio (the range of the projected
image). You can set the cropping range to Off, 4%, or 8%. When
the source is HDMI, Auto is available. When Auto is selected, it
automatically changes to Off or 8% according to the input signal.
Reset
You can reset all adjustment values on the Signal menu to their
default settings, except for Input Signal.
See the following to return all menu items to their default
settings.
s "Reset Menu" p.80
List of Functions
76
To Next Page
Loading...
Need help?
General
Weight and Dimensions
