Submenu Function
Projection
Select from one of the following projection methods
depending on how the projector is installed.
Front, Front/Ceiling, Rear, and Rear/Ceiling
You can change the setting as follows by pressing down
the [A/V Mute] button on the remote control for about five
seconds.
Front
W
Front/Ceiling
RearWRear/Ceiling
s "Installation Methods" p.20
Operation
Direct Power On: Set to On to turn on the projector
simply by plugging it in.
When the power cord is plugged in, note that the projector
turns on automatically in cases such as a power outage
being restored.
Sleep Mode: When set to On, this automatically stops
projection when no image signal is being input and no
operations are carried out.
Sleep Mode Timer: When Sleep Mode is set to On, you
can set the time before the projector automatically turns off
within a range of 1 to 30 minutes.
Lens Cover Timer: When set to On, this turns off the
power automatically 30 minutes after the A/V mute slide is
closed.
The default value is On.
High Altitude Mode: Set to On when using the projector
above an altitude of 1500 m.
Monitor Out Port (EB-W16 only): Changes the input and
output for the Monitor Out/Computer2 port. Select
Monitor Out when you want to output images to an
external monitor, and select Computer2 to input a
computer image signal or a component video signal for
video equipment.
Submenu Function
Standby Setup
(EB-W16 only)
Standby Mode: If you set Communication On, you can
perform the following operations even if the projector is in
standby mode.
• Monitoring and controlling the projector from a computer
s "Monitoring and Controlling" p.69
• Outputting analog RGB signals from the Computer port
to an external monitor
Standby Audio: If you set On, audio input to the Audio-
L/R port can be output to an external speaker even if the
projector is in standby mode.
Language
You can set the language for messages and menus.
Reset
You can reset the adjustment values for Display
*1
and
Operation
*2
from the Extended menu to their default
settings.
See the following to return all menu items to their default
settings.
s
"Reset Menu" p.80
*1When User's Logo Protect is set to On in Password Protect, settings related
to user's logo cannot be changed. You can make changes after setting User's
Logo Protect to Off.
s "Managing Users (Password Protect)" p.65
*2 Except for High Altitude Mode.
Info Menu (Display Only)
Lets you check the status of the image signals being projected and the status
of the projector. Items that can be displayed vary depending on the source
currently being projected. Depending on the model used, some input
sources are not supported.
List of Functions
79
To Next Page
Loading...
Need help?
General
Weight and Dimensions
