Introduction
10
Rear
Name Function
a
Speaker
The projector's built-in speaker. Outputs audio. Set Inverse Audio to On to
use the built-in speaker when the projector is suspended from a ceiling.
s Settings - Audio - Inverse Audio p.79
b
Power inlet
Connect the power cord. s p.24
c
Trigger Out port
Connects with external devices such as motorized screens. s p.19
d
RS-232C port
When controlling the projector, connect the projector to a computer with an
RS-232C cable. This port is for control use and should not normally be used.
s p.113
e
Audio (L-R) port
Inputs audio from equipment connected to the Video port, the Component
ports, or the PC port.
s p.18
f
Component port
Connects to the component (YCbCr or YPbPr) output port on video equip‐
ment.
s p.18
g
Security slot ( )
The security slot compatible with the MicroSaver security system manufac‐
tured by Kensington. For more details, visit the homepage of Kensington at
http://www.kensington.com/.
h
Audio Out port
Outputs audio during playback to external speakers. s p.19
i
Cable holder
When a cable is connected to a port, the weight of the cable may result in
imperfect insertion of its connector. In order to prevent this, put a commer‐
cially available clamping band (cable tie) through this holder to bind and fix
the cable.
j
Remote receiver
Receives signals from the remote control. s p.23
k
USB port (TypeA)
Connects USB devices such as a USB memory device or a digital camera, and
projects images as a slideshow.
s p.70
In addition, connects an optional wireless LAN unit.
s p.22
l
Service port
Service port. This is not normally used.
m
Video port
Connects to the composite video output port on video equipment. s p.18
n
HDMI2 port
Connects HDMI compatible video equipment and computers. s p.18
o
PC port
Connects to the RGB output port on a computer. s p.19
p
HDMI1 port
Connects HDMI compatible video equipment and computers. s p.18
In addition, connects MHL compatible smart devices or tablets.
s p.19
To Next Page
Loading...
