Configuration Menu
87
Info menu
Function Menu/Settings Explanation
Projector Info
Lamp Hours Displays the cumulative lamp operating time.
Source Displays the source name for the connected equipment cur‐
rently being projected.
Input Signal Displays the input signal.
Resolution Displays the resolution.
Scan Mode Displays the scan mode.
Refresh Rate Displays the refresh rate.
3D Format Displays the 3D format of the signal input during 3D projec‐
tion (Frame Packing, Side by Side, or Top and Bottom).
Sync Info Displays the image signal information.
This information may be needed if service is required.
Deep Color Displays Deep Color.
Video Signal Displays the signal type of the video device connected to the
Video port.
Status This is information about errors that have occurred on the
projector.
This information may be needed if service is required.
Serial Number Displays the projector's serial number.
Event ID Displays the application error log.
s p.101
Version
Main Displays the firmware version of the projector.
Video
Video2
Reset menu
Function Explanation
Reset All
Resets all items in the Configuration menu to their default settings.
The following items are not reset to their defaults: Panel Alignment, Lamp
Hours, Language, Network, Memory.
Reset Memory
Erases all settings saved using the Save Memory function.
Reset Lamp Hours
Resets the cumulative lamp hours use time to 0 H. Reset when you replace the
lamp.
To Next Page
Loading...
