Introduction
7
Name Function
l
Control panel
Control panel on the projector. s p.7
Control Panel
Buttons/Indicators Function
a
Flashes orange when it is time to replace the lamp. Shows the projector's errors
through a combination of other indicators lit and flashing.
s p.89
b
Operation indicator
Flashes to indicate warm-up in progress or cool-down in progress. Shows the
projector's status through a combination of other indicators lit and flashing.
s p.89
c
Turns the projector power on or off. s p.24
Lit when the projector is on.
s p.91
d
Changes to the image from each input port. s p.25
e
Selects the adjustment value for the volume and for menu items. s p.31
Performs horizontal keystone correction when the Keystone screen is dis‐
played.
s p.30
f
Selects adjustment values for menu items. s p.30
Performs vertical keystone correction when the Keystone screen is displayed.
s p.30
g
Brightness sensor
Detects the brightness of the room. When Color Mode is set to "Auto", the
optimum image quality is set according to the brightness detected by the sen‐
sor.
s p.32
h
Returns to the previous menu level when a menu is displayed. s p.74
i
Selects functions and settings when a menu is displayed. s p.74
j
Displays and closes the Configuration menu.
On the Configuration menu, you can make adjustments and settings for Signal,
Image, and so on.
s p.74
k
Flashes orange if the internal temperature is too high. Shows the projector's
errors through a combination of other indicators lit and flashing.
s p.89
To Next Page
Loading...
