Useful Functions
50
c
•
If you are using a device or cable that does not support 3D images, 3D projection cannot be performed.
•
For details on 3D format settings on the AV device, see the documentation supplied with the AV device.
•
When the 3D format has not been correctly set up, an image will not be correctly projected as shown
below.
•
If a 3D image is not projected correctly even when a 3D format is set, the synchronization timing for
the 3D glasses may be inversed. Inverse the synchronization timing using Inverse 3D Glasses.
s Signal - 3D Setup - Inverse 3D Glasses p.88
•
How a 3D image is perceived varies depending on the individual.
•
When you start projecting a 3D image, a warning about viewing 3D images is displayed. You can turn
off this warning by setting 3D Viewing Notice to Off.
s Signal - 3D Setup - 3D Viewing Notice p.88
•
During 3D projection, the following Configuration menu functions cannot be changed.
Aspect (set to Normal
*
), Noise Reduction (set to Off), Overscan (set to Off), Super-resolution, Image
Processing, Advanced - Sharpness, Picture in Picture
*
For the EH-TW6800 only, you can select Normal or Anamorphic Wide.
•
How the 3D image is viewed may change depending on the temperature of the surroundings and how
long the lamp has been used. Refrain from using the projector if the image is not projected normally.
Using 3D Glasses
Use the supplied or optional 3D Glasses (ELPGS03) to view 3D images.
s
p.128
c
The 3D Glasses come with protective stickers. Remove the protective stickers before use.
Charging the 3D Glasses
The following charging methods are available, depending on the model of 3D Glasses being used.
If you have a WirelessHD Transmitter, you can use it to charge the glasses.
If you do not have a WirelessHD Transmitter, you can charge by using a USB Charging Adapter (ELPAC01).
Charging using the WirelessHD Transmitter
Use the USB cable to connect the 3D Glasses to
the WirelessHD Transmitter.
When a cable is connected to the HDMI4 port, the
WirelessHD Transmitter cannot charge 3D
glasses.
Charging using the USB Charging Adapter
Use the USB charging cable to connect the 3D
Glasses to the USB Charging Adapter, and then
connect the USB Charging Adapter to an electrical
outlet.
Downloaded from www.vandenborre.be
To Next Page
Loading...
Need help?
General
